The client gets the IP address from the pool 10.10.0.0/16. The remote client uses the group name of RA (this is the IKEID) as well as the username of cisco and password of Cisco. In this example, the strongSwan client needs secure access to Cisco IOS software LAN network 192.168.1.0/24. The remote client receives an IP address from pool 10.10.0.0/16. Refer to Important Information on Debug Commands before you use debug commands. Use the Output Interpreter Tool in order to view an analysis of show command output. The Output Interpreter Tool ( registered customers only) supports certain show commands. Use the Command Lookup Tool ( registered customers only) in order to obtain more information on the commands used in this section. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration.

The information in this document was created from the devices in a specific lab environment. The information in this document is based on these software versions: VPN configuration on Cisco IOS software.StrongSwan is open source software that is used in order to build Internet Key Exchange (IKE)/IPSec VPN tunnels and to build LAN-to-LAN and Remote Access tunnels with Cisco IOS software.Ĭisco recommends that you have basic knowledge of these topics: This document describes how to configure strongSwan as a remote access IPSec VPN client that connects to Cisco IOS ® software.

Fortinet vpn client fedora